44
Chapter 2 Modifying a Patch

Lo-Fi

This effect intentionally degrades the audio quality to
simulate a Lo-Fi sound.
Bit Down: 0–7 Ctrl3
Lowers the audio quality. The audio quality will worsen as
this setting is increased.
S-Rate Down: 32, 16, 8, 4 Ctrl2
Coarsens the output signal. The sound will become coarser
as this setting is lowered.
Low EQ: -15–+15dB
Adjusts the level of the low frequency.
High EQ: -15–+15dB RTM, LFO, Ctrl1
Adjusts the level of the high frequency.
Output: Mono, Stereo
Specifies how the sound will be output. With a setting of
“Mono,” the output sound will be monaural.

Ring Modulator (RingModltr)

A ring modulator add the amplitude modulation to the
sound, giving a metallic character.
Frequency: 0–127 Ctrl1
Adjusts the frequency for modulation.
Character: 0–127 LFO, Ctrl2
Adjusts the tone. The high-frequency range will change.
Effect Level: 0–127 RTM, Ctrl3
Adjusts the output level of effect sound.
Direct Level: 0–127
Adjusts the output level of direct sound.

Stereo Chorus (Stereo Cho)

This is a stereo chorus. A filter is provided so that you can
adjust the timbre of the chorus sound.
PreDelay: 0.0–100ms
Adjusts the time delay from when the direct sound begins
until the processed sound is heard.
Rate: 0.05–10.0Hz LFO, Ctrl1
Adjusts the rate of modulation.
Depth: 0–127 Ctrl2
Adjusts the depth of modulation.
Phase: 0–180deg
Adjusts the spatial spread of the sound.
Filter Type: OFF, LPF, HPF
Selects the type of filter.
OFF: A filter will not be used. Cutoff will not be
displayed.
LPF: Cut the frequency range above the cutoff
frequency.
HPF: Cut the frequency range below the cutoff
frequency.
Cutoff: 200–8kHz Ctrl3
Adjusts the basic frequency of the filter.
Effect Level: 0–127 RTM
Adjusts the output level of chorus sound.
Direct Level: 0–127
Adjusts the output level of direct sound.