57
Chapter 2 Modifying a Patch
Chapter 2

Copying a Pad Set (Pad Set Copy)

You can copy the settings of a pad set to another pad set. You
can also copy to a different pad set of the same patch.
fig.2-34.e
1. In step 3 of “Basic Procedure for Copy” (p. 56), select
PadSetCpy.
2. After selecting the patch in step 5, strike a pad to select a
pad set.
* “PAD MIDI Note No.” cannot be copied.

Copying Pad/D Beam/Ribbon

Settings (Pad Copy)

Pad/D Beam/ribbon settings can be copied to another pad/
D Beam/ribbon.
fig.2-35.e
1. In step 3 of “Basic Procedure for Copy” (p. 56), select
PadCpy.
2. After selecting the patch in step 5, strike a pad (D Beam,
ribbon) to select it.
* “PAD MIDI Note No.” cannot be copied.

Copying Pad/D Beam/Ribbon

Settings to All Pads

(Pad Copy to All)

You can copy the settings of one pad/D Beam/ribbon to
every pad/D Beam/ribbon.
fig.2-35a.e
1. In step 3 of “Basic Procedure for Copy” (p. 56), select
PadCpToAll.
2. After selecting the patch in step 5, strike a pad (D Beam,
ribbon) to select it.
* “PAD MIDI Note No.” cannot be copied.

Exchanging Patch Settings

(Patch Exchange)

You can exchange the settings of two patches.
fig.2-36.e
1. In step 3 of “Basic Procedure for Copy” (p. 56), select
PatchExchg.

U0101B Conga

PadSetCpy U0201C

copy-destination pad set (patch number is blinking)
copy-source pad set

U0101A3 Conga

PadCpy U0101RL

copy-destineation pad (patch number is blinking)
Ribbon controller (left) is chosen in this figure.

U0101A1 Conga

PadCpToAll U0101

copy-destination patch number (blinking)
copy-source pad
U0101 Conga

PatchExchg U0102

exchange-destination patch number (blinking)
exchange-source patch