Roland KR-15 Using the Remote Control, Installing Batteries in the Remote Control, Distance

Chapter 3 Song Playback

Using the Remote Control

(Only for Instrument Equipped with CD Drive)

You can use the included remote control to easily start and stop performances and switch songs.

■Installing Batteries in the Remote Control

Install the batteries provided in the remote control.

1. Open the battery cover on the back of the remote control.

2. Insert the supplied AA batteries, as shown in the figure of remote control.

3. Close the battery cover.

■How to Use the Remote Control

When using the remote control, aim the remote control at the infrared receiver, keeping in mind the range of operation (below).

Infrared Receiver

Range of operation

CD Drive

Distance:

4 m (approximately 13 feet)

Angle:

30 degrees to the left and right of the receiver.

Remote Control

Precautions Concerning Use of the Remote Control

•The remote control is able to transmit only one operation at a time.

•The remote control may not operate even within the range of operation if there is an obstacle between it and the main unit.

•Using the remote control near other equipment that uses remote control systems may result in operational errors.

•The life of the battery depends on the amount and conditions of use. If the operational range of the remote control decreases, change the batteries.

•If you will not be using the remote control for a long period of time, remove the batteries.

NOTE

No remote control is included

with models that are not

equipped with a CD drive.

NOTE

Be careful to observe

the correct polarity (+, -

direction) when installing

the batteries.

Chapter 3

85