Polycom VP010 manual Locate the SVP Server, Install the SVP Server, Mount the SVP Server on a rack

SpectraLink 8000 SVP Server: Administration Guide for Mitel and Cisco

Locate the SVP Server

The SVP Server measures approximately 4 x 12.5 x 7 inches, and weighs about five pounds. The unit can be wall- mounted, vertically or horizontally, over ¾" plywood. The SVP Server can also be rack- mounted using a rack- mount kit (sold separately).

Locate the SVP Server in a space with:

•Sufficient backboard mounting space (for wall mount) and proximity to the LAN access device (switched Ethernet hub) and power source.

•Easy access to the front panel, which is used for cabling.

•A maximum distance of 325 feet (100 meters) from the Ethernet switch.

Install the SVP Server

The SVP Server may be mounted on a rack or to a wall.

Mount the SVP Server on a rack

The rack-mount kit is designed for mounting equipment in a standard

19-inch rack and should contain the following equipment:

†Mounting plates – two for each SVP Server to be mounted.

†Screws – four rack-mount screws for each SVP Server to be mounted.

To rack-mount the SVP Server:

1.Remove the corner screws from the SVP Server.

2.Screw the U-shaped end (round screw holes) of the two mounting plates to the SVP Server.

3.Screw the other end of the two mounting plates (oblong screw holes) to the rack.

4.Repeat steps 1-3 for each additional SVP Server. The mounting plate is designed to provide the correct minimum spacing between units. When mounting multiple units, stack the units in the rack as closely as possible.

20 PN: 1725-36031-001_H.doc