60
Settings (Edit mode)
Entering channel/block data If the system exclusive message contains a channel or GS block number, use the following procedure to specify the type and the value of the upper bits. A channel or block number
corresponding to the current channel (p. 33) will be inserted into the lower bits.
The block number is not actually a channel; it corresponds to the “part” of a GS sound module. On the PCR, it corresponds to the channel for the sake of convenience.
For a specific example, refer to system exclusive assign
Bend Pitch Control
(p. 63).
1
At the location where you want the channel/block number to be inserted, press the [DATA] button several times to select “0CH” for the channel or “0BL” for the block.
fig.chbl.eps_70
* The - - portion shows the currently specified value.
2
Use controllers [A1]–[A8] to enter the value of the upper four bits.
The “0” in the display will change to the number you enter.
3
Press the [ENTER] button.
current channel 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
CH 0 1 2 3 4 5 6 7 8 9 A B C D E F
BL 1 2 3 4 5 6 7 8 9 0 A B C D E F
[DATA] [DATA]
[DATA]
[DATA]
PCR-300_500_800_e.book 60 ページ ２００６年１２月１９日 火曜日 午後２時５９分