Roland RG-1 Opening and Closing the Lid, Connecting the Pedal Cord and the Power Cord

15
Before You Start Playing
fig.00-0350
1.
To open the lid, hold handles with both hands
and lift it straight up. Then, slide it to the rear.
2.
To close the lid, hold handles with both hands
and slowly pull it forward until it stops. Then,
gently lower it into place.
• When opening and closing the lid, be careful not to let
your fingers get caught. Small children should use it
only under the supervision of an adult.
• When moving the piano, for safety’s sake be sure to close
the lid first.
• Make sure you don’t have anything (such as sheet
music) on the keyboard when you close the lid.
fig.00-370
1.
Plug the pedal cord into the Pedal jack in the jack
panel on the RG-1’s bottom left panel.
2.
Connect the supplied power cord to the AC inlet
located in the jack panel.
3.
Secure the pedal cord and power cord in place
with the cord clamps, after affixing them at
locations A, B, and C (recommended) as shown in
the figure below.
4.
Secure the power cord in place with the cord
clamps, after fixing them with screws at locations
D, E, and F in the figure below.
fig.00-0380
5.
Plug the power cord into an AC outlet.
Opening and Closing the Lid Connecting the Pedal Cord
and the Power Cord
ABC
ABC
D
E
F
D
E
F
Cord Clamps
(using double-sided tape)
Cord Clamps
(using screws)
RG-1_e.book 15ページ ２００８年４月８日 火曜日 午後２時３６分