Keyboard command descriptions
Command mode –
Entering the command mode sends the remote units keyboard instructions to the CrystalView Plus instead of the connected computer. In the command mode, the yellow LED on the remote units RJ45 connector for channel 1 will light indicating that the unit is in the command mode. The keyboard status LEDs (Num lock, Caps Lock, and Scroll Lock) will flash indicating which channel is selected. The Command mode automatically times out after 30 seconds of inactivity, saves all settings, and returns the keyboard to normal functions.
Number of keyboard |
|
|
status LED flashes | Video channel selected | |
1 | Channel 1 (Default, all models) | |
2 | Channel 2 | (Dual & Quad models) |
3 | Channel 3 | (Quad models) |
4 | Channel 4 | (Quad models) |
Slow flashes | Channel 0 | (All channels) |
Table 2. Channel select
Exit Command mode and save – [Esc]
Pressing the Esc key while in the command mode will save all configuration changes made and exit the command mode.
Exit Command mode without saving – [L-Shift] + [ESC]
Pressing the left shift key and the Esc key while in the command mode will exit the command mode without saving any configuration changes.
Select Channel 1 – [1]
Pressing 1 while in the command mode selects channel one and all configuration adjustments apply to channel 1 only. Keyboard status LEDs flash once.
Select Channel
Pressing 2, 3, or 4 while in the command mode selects that channel and all configuration adjustments apply to the selected channel only. Keyboard status LEDs flash twice for channel 2, three times for channel three, and four times for channel four.
Select Channel 0 – [0] (Dual and quad models only)
Pressing 0 (zero) while in the command mode selects all channels and all configuration adjustments are applied to all channels.
This is especially helpful if all cable lengths and types used for all channels are the same.
CRYSTALVIEW PLUS INSTALLATION AND OPERATIONS MANUAL |
|
| 19 |
|
|
|
|
|
|
