INSTALLATION 6 ULTRAVIEW REMOTE 2 INSTALLATION AN D OPERATIONS MANUAL
UltraView Remote 2 Installation
Installing the UltraView Remote 2 is a very easy process and should be performed by a designated administrator.
The administrator will install, configure, and set-up user access profiles. A network administrator will need to ass ign
an IP address to the unit (if needed) and set-up firewall and network access to the unit.
The following installation procedure is a guide to proper ly install and configure the UltraView Remote 2. The
following items are needed to install the UltraView Rem ote 2:
1. A valid IP address to assign to the unit (if not using DHCP f eature)
2. VGA monitor
3. PS/2 keyboard
4. PS/2 mouse
5. RJ45 network cable
6. KVM Adapter cable (DB25M to PS/2F-PS/2F-HD15F)
7. CPU Adapter cable(s) (DB25M to PS/2M-PS/2M-HD15M)
Connecting the KVM station
Connect the KVM stations PS/2 keyboard, video monitor and PS/2 mouse cables to the corresponding connectors on
the KVM adapter cable as shown in Figure 2. The KVM station’s v ideo monitor should be equal or better than any of
the connected computers. Connect the DB25M end of the KVM c able to the KVM DB25F port on the rear panel of
the UltraView Remote 2 unit.
Figure 2. Connecting a KVM
KVM Adapter Cable
KVM Station