ULTRAVIEW REMOTE 2 INSTALLATION AN D OPERATIONS MANUAL 31
Figure 17 shows the VNC Viewer toolbar and an explanat ion of each toolbar tab. The VNC viewer uses a two mous e
cursor technique to identify if you are working on the VNC Viewer or the remote PC’s desktop. The local cursor is
the dot and the arrow cursor is the host computers desk top. When you move the cursor, the arrow cursor will follo w
the dot cursor. When you move the cursors off of the host com puter’s desktop onto the remote computer’s desktop,
a single arrow cursor will be present for local cursor ac tivity.
The first time you connect to the UltraView Remote 2 or switch CPU ports the cursors may be out of sync. Click on
the Calibration tab on the toolbar and calibrate the Video + Mouse. After the calibration is com plete, the mouse
cursors will follow each other over the viewer window.
Figure 17. VNC Viewer Toolbar
When you click on the “Controls” tab, the below dropdown m enu will display.
65
Single Mouse Mode
This mode is for fast network connections where the curs or response is sufficient to provide instant visual feedback
on the remote screen. When enabled, the cursor is ‘captured ’ within the viewer window until you use the ‘escape’ ho t
keys. To escape from the single mouse mode, press F8 and t hen P. The single mouse mode does not require
calibration and available only when using the VNC viewer.
Resync Mouse
This option has the same effect as the button on the menu bar and resynchronizes the local and remote mouse
pointers.
Refresh Screen
This option refreshes the whole screen image to remove any artefacts from moved screen items. This is useful when
using very low refresh rates on slow speed communication l inks.