3 Installing Your EM1
•Plug pigtail from monitor into interface cable in
•Coil excess (service loop) wire in
•Replace base cover.
•Test for stability and desired range of motion.
Installing Tuner module
•Place Tuner module in desired location ( Dry Flat Place)
•Plug in Interface cable to proper location.
•Screw in cable to proper connector.
•Plug in power adapter to wall plug.
•Plug in power adapter into Tuner module.
Page 8
3 Installing Your EM1
B. Mounting of Components (Cont.)
Table Top or Under Counter Mount
•Use the Mounting base plate as a template to mark mounting holes
•Mount base plate to monitor using
Note :
Mounting plate is only used when you want to surface mount your EM1 interface cable
•Select Appropriate cable
•Route 15ft interface cable from
•Plug pigtail from monitor into interface cable in
•Coil excess (service loop) wire in
•Replace base cover.
•Test for stability and desired range of motion.
Page 5
