Rosen Entertainment Systems EM-1 manual Mounting on Wall to J-Box

3 Installing Your EM1

1

3

4

2

Note :

Mounting plate is only used when you want to surface mount your EM1 Interface cable

3 Installing Your EM1

C. Mounting on Wall to J-Box

•The EM1 is designed to mount in a round 3 1/2” electrical junction box (J-Box) like the one shown below.

J-Box

Note:

A J-box may be purchased at any local hardware store

•Make sure J-Box is secure before mounting monitor assembly.

•Route 15ft interface cable from j-box to desired Tuner module location.

•Use a 1/8” standard flat screw driver to remove the base cover using the access notch as shown below. When removing, be careful not to scar or damage cover.

1.4screws 10-32 x 1 Fhp 100 degree 2. # 10 washer ss 100 degree

3. Mounting baseplate

4. EM1 Main FPD Assembly

Page 6

Page 7