SATA+ULTRA ATA RAID CONTROLLERRC212 | User Manual | |
|
|
|
RAID 1 (Mirroring)
For New/Blank Hard Drives
1.As the BIOS boots press Tab when prompted to enter the RAID BIOS.
2.At the RAID utility main menu select Create Array, press Enter.
3.At the next screen select Auto Setup For Data Security, press Enter.
4.When asked Auto Create array will destroy all data on disks. Continue? (Y/N), press Y to accept.
5.And then a Create New Raid Success!! Message will be displayed. Press ESC to quit then go back to the RAID utility main menu.
6.Press ESC to exit the BIOS.
7.When asked Do you really want to exit the utility? (Y/N), press Y to accept.
For Existing Hard Drives with Data
1.As the BIOS boots press Tab when prompted to enter the RAID BIOS.
2.At the RAID utility main menu select Create Array, press Enter.
3.At the next screen select Array Mode RAID 1 (Mirroring), press Enter.
4.At the next screen select RAID 1 for data protection, press Enter.
5.At the next screen select Select Disk Drives, press Enter.
6.Please use arrow keys ↑and ↓ to select the Source drive, press Enter.
7.Please use arrow keys ↑and ↓ to select the Mirror(Target) drive, press Enter.
8.Select Start Create Process, press Enter.
9.When asked Save the data on source disk to mirror after creation? (Y/N), press Y to accept.
10.The set will be built. The status of the built is displayed in the menu.
11.When build is completed, a Create New Raid Success!! Message will pop up inform
9
