Royal Sovereign RSL-2702, Laminator owner manual Control Of Roller Pressure, Control Panel

7. CONTROL OF ROLLER PRESSURE

To set, pull the pressure lever outward and turn to one of the following positions.

OPEN: For detaching and cleaning rollers. ￿6MM: For laminating 6mm[0.24in] thick board. ￿!￿￿5MM: For laminating 5mm[0.2in] thick board. ￿"3MM: For laminating 3mm[0.12in] thick board.

1.5MM: For laminating 1.5mm[0.06in] thick board.

￿￿￿￿LAMINATING: For laminating 25~250micron(1~10mil) thick film and cold film.

￿￿￿￿￿￿￿￿￿

9

RSL-2702

8.CONTROL PANEL

1.UPPER: To change upper roller temperature by pressing button, then up or down arrow.

(range 32~302°F or 0~150°C)

2. LOWER: To change lower roller temperature by pressing button, then up or down arrow. (range 32~302°F or 0~150°C)

3. SPEED: To change speed of the rollers by

pressing button, then up or down arrow. (range 1 through 9)

4. MEMORY: To recall or change presets. To recall the settings, press MEMORY

then up or down arrow. To save the settings,

set desired temperatures and speeds then ,'4

press the MEMORY button twice.

(stores up to 9 different settings)

5.C/HOT: To change the mode from hot to cold or cold to hot lamination. In cold mode, the speed defaults to 2 (speed 1~4 settings) and stand-by function is disabled.

6.T-CHECK: To check current upper and lower roller temperatures.Display automatically returns to the previous settings after 5 blinks.

7.ST/BY: To change to stand-by mode (temperature will automatically reset to 176°F (80°C). While in this mode, all the buttons on the control panel are disabled. Press ST/BY mode button to resume normal operation.

NOTE: Auto stand by mode and auto power off mode

-Stand by mode: If no activity is made within 2 hours after each use the machine will automatically switch into stand by mode.

-Auto power off mode: If the machine is in stand by mode and no activity is made for 60 minutes the machine will automatically power off.

-If any activity is made while in stand by or auto power off mode the machine will return to it's previous stage.

8.REV: To reverse the rollers. Must press and hold the button to activate.

9.STOP: To stop the rollers from turning.

10.RUN: To start the rollers .

11.FAN: To activate the cooling fans.

10