9.2.COLD LAMINATING
1.Put cold roll film on upper shaft. Load backing paper on the lower shaft as per illustration 6.2 on page 7.
2.Pull COLD film and fix it so that the Release Liner can be wound on
3.Set pressure lever to the proper position according to your laminating condition.
4. | After pressing the | button, choose and | |
| set proper speed by using the | and | |
|
| button. |
|
5. | It is | when ready is dispalyed | |
| on the screen and beeps three times. | ||
6.Turn on the take up device and set the proper film tension by pressing the RUN "button. Lower tension would make better operation.
7.Center the document on the table. For ease and convenience set the document guides in position
8.Press the RUN "button and "take up motor" at the same time.The liner and film will roll at the same time.
9.When lamination is completed, press the 
button.
10.Set pressure lever at the "OPEN" mode.
11.Turn off the power switch.
10. USING CROSS CUTTER
The cross cutter is located on the rear exit table of the machine.
1.After lamination, move the cutter approximately to the center of the completed application at the desired point of detachment (Figure 1).
Figure 1
2.Grasp film with one hand, press the cutter downward into the application and slide it first to one end of the application, then to the other end to complete the cut.
(Figure 2 & 3)
Figure 2
Figure 3
13 | 14 |
