2.COLD LAMINATING
1.Put cold roll film on upper bar.
(Set the same as method of HOT film for protect paper of lower part)
+
2.Pull COLD film, and fix it so that backside protecting paper can be wound on the
3.Set pressure lever at the proper position following to your lamination condition.
4.After pressing the C/HOT button choose and set proper speed by using the SPEED
and 
button.
5.It is 
when ready is show on the screen and the buzzer rings three times.
6.Turn on the take up device and set the proper film tension by pressing the RUN 
button. Lower tension would make better operation.
7. Set document on the table.
You should allow at least 5mm(1/4”) space on each side for perfect laminations
8. Turn the switch “Run” and "take up motor" at the same time. The liner and film wii be rolled at the same time.
9.When the lamination is finished, press the STOP 
button.
For your convenience, it would be better to set table guide in proper position. And if needed, cut documents with cross cutter.
10.Set pressure lever at the Hard board/1mm(40mil) mode.
11.Turn off the power switch.
*** Reference ***
1.Set up the protection paper. Otherwise, glue form the film will be stuck on the face of th and it can be seriously damaged.
2.Turn the switch “Run” and “Take up motor” at the same time.
3.For worm lamination, set temperature from the hot mode.
- 21 -
