Royal Sovereign RSS-1200, RSS-1050, RSS-685 Its not out of order, Symptom Cause Check point

It's not out of order

Symptom		Cause		Check point
Rollers do not operate	1.	Power cord may not be plugged	1.	Check the power cord
after press RUN		in.	2.	Check the switch is on
button.	2.	Power switch is at OFF mode.	3.	Check the emergency switch
	3.	Emergency switch may be at		is off
		ON mode.	4.	Release STND-BY switch by
	4.	It may stay at STAND-BY mode.		press the STND-BY button
Heat shoe is not	1.	It is set at the cold mode	1.	Change the function to hot
heater up.	2.	Memorized temp may be lower		lamination.
		than atmosphere temp.	2.	Set proper temperature for the
				work
*Noise from friction	1.	Film tension is too tight.	1.	Adjust the film tension.
between the shoe	2.	Temperature of heat shoe is too	2.	Reduce the friction noise by
and film is loud, while		high		adjusting temperature on the
machine's operating				heat shoes.
at a slow speed.
*Wrinkled lamination	1.	Film tension is not proper, too	1.	Adjust film tension.
result		tight.	2.	Put the Idle Bar at right position.
	2.	Idle Bar in line with lower roller
		is not in proper position.
*Result of lamination is	1.	Temperature on the heat shoe	1.	Increase the temperature on the
not clear		is too low or lamination is too		heat shoe or decrease the
		speedy.		speed.
		SPARE PARTS
1. Core(76mm) :6EA		4. Bolt(M8X12) : 6EA

2.	Fuse(50T) : 1EA	5.	Washer-spring(Φ8) : 6EA
	(AC 250V 6.3A)
3.	Fuse(65TS) : 1EA	6.	Bolt-core : 2EA
	(AC250V 15A)

- 25 -