Runco DLC-2000HD user manual Front and Rear Panel Descriptions, Front Panel

Front and Rear Panel Descriptions

Front Panel

1 2 3

ratio

< enter

<>

<

ratio

i n p u t

menu

1. IR RECEIVER	4	5 6 7	8	9	10
Receives the infrared signal from the remote control.

2. POWER BUTTON

Turns the unit ON or OFF. The Main Power switch on the rear of the unit must be on first for this button to be active.

3.POWER INDICATOR

When the PFP Controller is ON, this LED will illuminate GREEN. When the unit is OFF or in STANDBY, this LED will illuminate RED. A flashing red light indicates a fault. If this happens, unplug the unit for 2 minutes and re-try. A yellow LED indicates a communication problem; double check that the ComLink cable is connected properly (pg. 8).

4.LED DISPLAY

Indicates the model number, current source, resolution and aspect ratio.

5.UP BUTTON

When no menu is present on-screen, this button will toggle you through the different aspect ratios. When the menu is on-screen, the UP button will move the cursor up within a menu.

When an adjustment item has been selected (i.e. brightness), the UP button will increase the value of that function.

6.LEFT BUTTON

When no menu is present on-screen, the LEFT button will toggle you through the five different sources, in the order of:

RGB HD Component HD Component S-Video Composite

7.ENTER BUTTON

When an item is highlighted on the On-Screen Display, the ENTER button will select the item.

8.DOWN BUTTON

When no menu is present on-screen, this button will toggle you through the different aspect ratios. When the menu is on-screen, the DOWN button will move the cursor down within a menu.

When an adjustment item has been selected (i.e. brightness), the DOWN button will decrease the value of that function.

9.RIGHT BUTTON

When no menus are present on-screen, the RIGHT button will toggle you through the five different sources, in the order of:

Composite S-Video Component Component HD RGB HD

10.MENU BUTTON

The MENU button brings up the main adjustment menu. After making adjustments, the MENU button will bring you back to the sub-menu, then to the main menu. The menu will then either time-out after approximately 10 seconds, or pressing the MENU button will remove the menu immediately.

7