Runco VX-44D 4. DHD Controller Front Panel 1. RUNCO ICON, Ir Sensor, Up Button, Left Button

Controls and Functions

2.4

DHD Controller Front Panel

Figure 2-4shows the controls and indicators on the DHD Controller front panel; the paragraphs that follow describe them.

1 2 3 4 5 6 7 8 9 10

Figure 2-4. DHD Controller Front Panel

1.RUNCO ICON

Lights red to indicate that the DHD Controller is in standby mode; lights blue to indicate that the unit is on.

2.POWER BUTTON

Press once to toggle from standby mode to on mode. Press it again to return to standby mode. For a discrete on or off command, you can use the direct access buttons on the remote control.

3.IR SENSOR

Receives IR commands from the remote.

4.VACUUM FLUORESCENT DISPLAY

Can be used instead of the On-Screen Display (OSD). Displays currently-selected menu or – if no menu is selected – the current source, signal format (NTSC or PAL), input resolution and aspect ratio.

5.UP BUTTON

Use to direct select aspect ratios or move the menu cursor up in the OSD. When no menu is present on-screen, the UP button toggles through aspect ratios in the following order:

16:9 - 4:3 - Letterbox - VirtualWide - Cinema - Virtual Cinema

Note	Virtual Cinema is available only on the VX-44d/-55d/CineWide. For
	more information about aspect ratios, refer to Table 4-1.

6.LEFT BUTTON

Used to direct select inputs or move the menu cursor left in the OSD. When no menu is present on-screen, the LEFT button toggles through the different sources, in this order:

HDMI 2 - HDMI 1 - HD/RGB2 - HD/RGB1 - Component SD - S-Video 2 - S-Video 1 - Composite

10 Runco VX-44d/-55d Owner’s Operating Manual