Runco VX-55D, VX-44D manual Turning on the Power, Component SD NTSC, 480i, 169Vx44/55

Installation

1.Turn on your source components.

2.Turn on the main power switch at the rear of the DHD Controller.

3.If this is an AutoScope-equipped projector, turn on the main power switch at the rear of the AutoScope lens motor. The lens motor power switch is located next to the AC input (see Figure 3-14).

4.Press the ON button on the remote control – or the POWER button on the DHD Controller front panel – to turn on the system. The vacuum fluorescent display on the DHD Controller front panel briefly displays “Starting Display.”

The LED status window at the rear of the projector displays an active pattern of segments to indicate that it is changing its state from “standby” to “on.”

5. When the projector has completed its initialization and is ready for use, “On” appears in the projector LED status window.

The fluorescent display on the DHD Controller indicates the active source, signal format (NTSC or PAL), input resolution and aspect ratio; for example:

		Input
Current Source	Format	Resolution

3.8

Turning on the Power

Component SD NTSC 480i

16:9Vx44/55

Aspect Ratio

Runco VX-44d/-55d Owner’s Operating Manual 37