Russound manual ST2-XMTUNER PROGRAMMING, ST2 TUNER SETUP MENU, ST2 Chassis Setup Menu

ST2-XM TUNER PROGRAMMING

ST2 TUNER SETUP MENU

ST2-XM Tuner Setup Menus

Note: The Setup Menu procedures must be performed from the ST2-XM Tuner front panel.

The ST2-XM Tuner Setup Menus provide setup and naming procedures for the ST2-XM main chassis, the XM tuner module and the AM/FM tuner module. These procedures include source number assign- ments, assigning a custom name to a memory preset or a bank, choosing a region for AM/FM opera- tion (US or Euro), factory initialization and system information.

If the ST2-XM is used with a non-RNETsystem, the ST2-XM can be connected and operated without any setup programming. Follow the setup menus if custom names are desired, or for system info.

If the ST2-XM is used with an RNET system such as CAV6.6, the following minimum setup must be performed for the ST2-XM to be properly controlled by the CAV6.6.

1.ST2 Chassis Setup Menu - Assign source numbers to Tuner 1 and Tuner 2.

2.CAV6.6 Source Setup Menu - Assign the corresponding source numbers to Tuner 1 and Tuner 2.

3.CAV6.6 Source Setup Menu - Assign command type PERIPHERAL to Tuner 1 and Tuner 2.

NOTE: Once the programming procedures are completed, cycle power first to the Tuner and then to the CAV6.6 (must be powered on last) to establish a connection.

ST2 Chassis Setup Menu

Source Number (Chassis)

The Source Number procedure permits Tuner 1 (XM) and Tuner 2 (AM/FM) to be assigned the proper peripheral source identities as will be assigned in the CAV6.6 Source Setup.

1.Enter the Setup Menu by pressing and holding the TNR SEL button.

2.TUNER SETUP appears. Press MEM Up/Down until SOURCE NUM appears on the tuner.

3.Press BAND. TUNER # appears.

4.Press the Tune Up/Down buttons to select the Tuner # (Tuner 1 is XM, Tuner 2 is AM/FM).

5.Press BAND. SOURCE NUM appears.

6.Press the Tune Up/Down buttons to scroll through the source numbers 1-6.

7.Press BAND to select the source number (as assigned in the CAV6.6 setup process).

8.Repeat the process for the next tuner.

9.Press TNR SEL to exit the Source Number menu.

Update Firmware (Chassis)

The Update Firmware procedure allows the ST2 tuner’s OS firmware to be updated. The proce- dure is performed using a DB9 serial cable with one end connected to the RS-232 port on the back of the tuner and the other connected to a PC or laptop. If an OS firmware update is avail- able, it can be obtained through the Document Center at www.russound.com. XM tuner module firmware must be performed by an authorized Russound service facility.

1.Enter the Setup Menu by pressing and holding the TNR SEL button.

2.TUNER SETUP appears. Press MEM Up/Down until UPDATE FIRMW appears on the tuner.

3.Press BAND to enter the UPDATE FIRMW menu.

26