STARTING/STOPPING INSTRUCTIONS
STARTING
1.MIX OIL WITH GAS per instructions (page 8).
2.FULLY PRESS AND RELEASE THE PRIMER BULB UNTIL FUEL IS VISIBLE IN BULB. See Fig. 14 for the primer bulb location.
Primer |
Bulb |
Fig. 14
3.PLACE THE CHOKE LEVER IN THE FULL "CHOKE" POSITION. See Fig. 15.
Fig. 15
4.HOLD THE BLOWER/VAC IN THE STARTING POSITION (Fig. 16 for blower, Fig. 17 for vacuum).
Fig. 17
5.SQUEEZE THE THROTTLE TRIGGER TO FULL THROTTLE. Hold the trigger in this position.
6.PULL THE STARTER ROPE BRISKLY until you hear the engine sounds like it wants to run (normally 2 to 5 pulls).
7.PLACE THE CHOKE LEVER IN THE "PARTIAL" POSITION. Pull the starter rope briskly 1 to 3 times to start the engine. See Fig. 15.
NOTE: If the engine does not start immediately, repeat steps 2 through 7.
8.After the engine warms up for 5 to 10 seconds,
PLACE THE CHOKE LEVER IN THE "RUN" POSI- TION. See Fig. 15.
STOPPING
To stop the engine, push and hold the stop button until the engine comes to a complete stop (Fig. 18).
NOTE: To prevent vapor lock, avoid setting the unit in the sun.
Fig. 16
Fig. 18
10
