Ryobi BT3100-1 To Install Accessory Table and RIP Fence, REMOVING/REPLACING the Throat Plate

ASSEMBLY

TO INSTALL ACCESSORY TABLE AND RIP FENCE

■Place the accessory table on the front and back rails, fitting the lips into the top slot of the rear rail. Position the slot on the underside of the accessory table onto the front rail and tighten the lever securely.

■Remove the scale indicator assembly from the plastic bag and install on either side of the rip fence. The pan head screw (#8-32 x 1/2 in.) goes on the outside of the front block. The scale indicator and hex nut (#8-32) go immediately behind the front lip of the front block.

■To install the rip fence, place the rear lip on the rear rail and pull slightly toward the front of the unit. Lower front end onto the guide surfaces on top of the front rail. Check for a smooth gliding action. Swing the locking handle down to automatically align and secure the fence.

REMOVING/REPLACING THE THROAT PLATE

See Figure 16.

WARNING:

Make sure the switch is off and the plug is out of the outlet. Failure to do so could result in accidental starting, result- ing in serious personal injury.

WARNING:

Drop blade below saw table when reinstalling the throat plate. Failure to heed this warning could result in serious personal injury.

■To remove the throat plate, first remove the screw holding the throat plate with a phillips screwdriver and lift the front end. Pull throat plate out toward the front of the saw.

■To reinstall the throat plate, drop blade below saw table and place throat plate in the opening. Push throat plate toward the rear of saw base to engage the spring clip.

■Securely tighten throat plate screw.

	ACCESSORY
	TABLE
TO	REAR RAIL
LOCK	LEVER

FIT LIP OF TABLE

INTO REAR RAIL

TO

UNLOCK

MOUNTING

HOLE FRONT

SCREW BLOCK

	REAR LIP
	RIP FENCE
	REAR RAIL
HEX NUT
SCALE	FRONT LIP
INDICATOR
	Fig. 15
THROAT
PLATE
	SCREW

Fig. 16

Page 18