OPERATION

CHARGING YOUR DRILL-DRIVER

This tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it overnight prior to use.

Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by re- charging) for them to become fully charged.

TO CHARGE MODEL HP62

Charge only with the charger provided.

Connect charger to the tool by inserting charger plug into input jack. Note: As shown in figure 2, input jack is located at rear of tool.

Make sure power supply is normal household volt- age, 120 volts, 60 Hz, AC only.

Connect charger to power supply.

TO CHARGE MODEL HP722

Charge only with the charger provided.

Connect charger to the battery pack by inserting charger

 

plug into input jack. Note: As shown in figure 3, input

 

jack is located at rear of battery pack.

MODEL HP62

CHARGER

CHARGE

INDICATOR

LIGHT (LED)

INPUT

JACK

CHARGER

PLUG

Fig. 2

MODEL HP722

BATTERY

Note: Battery pack for Model HP722, can be removed

from the drill to be charged. See Figure 3. To remove

battery pack from drill, follow instructions on page 9.

Make sure power supply is normal household volt-

CHARGER

PACK

age, 120 volts, 60 Hz, AC only.

■ Connect charger to power supply.

MODEL HP62 AND HP722

The charge indicator light (LED) indicator, which is located on rear of drill, will light up when charger is properly connected to power supply. This red light indi- cates your battery is charging and will remain on until charger is disconnected from power supply.

Note: During the two year warranty period on drill Model HP722, if the charge indicator light (LED) fails to come on or goes out while charging battery pack, re- turn charger and battery pack to your nearest autho- rized service center for repair or replacing. If you have drill Model HP62, return charger to service center.

After normal usage, 3 hours or less of charging time is required to fully recharge battery pack. Note: If battery pack is completely discharged, 6 hours or longer of charging time is required to fully recharge battery pack.

The charger housing and the tool handle will become slightly warm to the touch while charging. This is nor- mal and does not indicate a problem.

DO NOT operate drill while it is connected to the charger. The driving ability will not increase.

DO NOT place charger in an area of extreme heat or cold. It works best at normal room temperature.

When battery pack has been charged, disconnect charger from power supply. This practice will increase battery life.

Page 8

INPUT

JACK

CHARGE

INDICATOR

LIGHT (LED)

CHARGER

BATTERY

 

PACK

INPUT

JACK

CHARGE

INDICATOR

LIGHT (LED)

CHARGER

PLUG

Fig. 3

Page 8
Image 8
Ryobi manual Operation, Charging Your DRILL-DRIVER, To Charge Model HP62, To Charge Model HP722