OPERATION

IMPORTANT INFORMATION FOR

RECHARGING HOT BATTERIES

When using your drill-driver continuously, the batteries be- come hot. You should let the batteries cool down for approxi- mately 30 minutes before attempting to recharge.

Note: This situation occurs when continuous use of your drill- driver causes the batteries to become hot. It does not occur under normal circumstances. Refer to "Charging Your Drill- Driver" for normal recharging of batteries. If the charger does not charge your batteries under normal circumstances, return both the drill-driver and charger to your nearest AUTHO- RIZED SERVICE CENTER for electrical check.

For more information on the battery recycling call

1-800-8 BATTERY.

WARNING:

If any parts are missing, do not operate tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.

SWITCH

See Figure 4.

Your drill starts and stops by depressing and releasing the switch trigger.

Your drill has a two-speed feature in the switch. Depress the switch trigger halfway for driving screws at low speed. Depress the switch trigger all the way for normal drilling. Release the switch trigger to turn drill OFF.

SWITCH LOCK

See Figure 4.

The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use. To lock the switch trigger, place the direction of rotation selector in the center position.

TO INSTALL BATTERY PACK MODEL HP722

Place the direction of rotation selector in center posi- tion. See Figure 4.

Place the battery pack in your drill. Align raised rib on bat- tery pack with groove in drill's battery port. See Figure 5.

Make sure the latches on each side of your battery pack snap in place and that battery pack is secured in drill before beginning operation.

TO REMOVE BATTERY PACK MODEL HP722

Place the direction of rotation selector in center posi- tion. See Figure 4.

Locate latches on side of battery pack and depress both sides to release battery pack from your drill. See Figure 5.

Remove battery pack from your drill.

DIRECTION

OF ROTATION SELECTOR

REVERSE

0

 

1

3

5

CENTER

POSITION (LOCK)

FORWARD

 

SWITCH

 

TRIGGER

Fig. 4

 

MODEL HP722

01

5

BATTERY

PACK

BATTERY

PORT

LATCHES

DEPRESS LATCHES

TO RELEASE

BATTERY PACK

Fig. 5

CAUTION:

When placing battery pack in your drill, be sure raised rib on battery pack aligns with groove in drill's battery port and latches snap in place properly. Improper assembly of battery pack can cause damage to internal components.

Page 9

Page 9
Image 9
Ryobi HP62 manual Important Information for Recharging HOT Batteries, To Install Battery Pack Model HP722