ADJUSTMENTS
WARNING:
To prevent accidental starting that could cause serious personal injury, always remove the battery pack from the tool when making adjustments.
The compound miter saw has been adjusted at the factory for making very accurate cuts. However, some of the components might have been jarred out of alignment during shipping. Also, over a period of time, readjustment will probably become necessary due to wear. After unpacking the saw, check the following adjustments before you begin using saw. Make any readjustments that are necessary and periodically check the parts alignment to make sure that the saw is cutting accurately.
CAUTION:
Do not start the compound miter saw without checking for interference between the blade and the throat plate. Damage could result to the blade if it strikes the throat plate during operation of the saw.
PIVOT ADJUSTMENTS
NOTE: These adjustments were made at the factory and normally do not require readjustment.
TRAVEL PIVOT ADJUSTMENT
nThe saw arm should rise completely to the up position by itself.
nIf the saw arm does not raise by itself or if there is play in the pivot joints, have saw repaired at your nearest
RYOBI AUTHORIZED SERVICE CENTER.
BEVEL PIVOT ADJUSTMENT
nThe compound miter saw should bevel easily by loosening the bevel lock knob and tilting the saw arm to the left.
nIf movement is tight or if there is play in the pivot, have saw repaired by at your nearest RYOBI AUTHORIZED
SERVICE CENTER.
DEPTH STOP
The depth stop limits the blade’s downward travel. It allows the blade to go below the miter table enough to maintain full cutting capacities. The depth stop positions the blade 1/4 in. from the miter table support.
NOTE: The miter table support is located inside miter table.
The depth stop is factory set to provide maximum cutting capacity for the
However, when the diameter of the blade has been reduced due to sharpening, it may be necessary to adjust the depth stop to provide maximum cutting capacity. Also, when a new blade is installed, it is necessary to check the clearance of the blade to the miter table support before starting the saw. Make adjust- ments if needed.
DEPTH STOP ADJUSTMENTS
See Figure 43.
nRemove the battery pack from the tool.
nTo adjust the depth stop use a 17 mm wrench or adjust- able wrench and loosen the hex nut at the rear of the miter saw arm.
�n Use the 5 mm hex key provided to adjust the depth stop adjustment screw. The saw blade is lowered by turning the screw counterclockwise and raised by turning the screw clockwise.
nLower the blade into the throat plate of the miter table. Check blade clearance and maximum cutting distance (distance from fence where blade enters) to front of miter table slot.
nReadjust if necessary.
DEPTH STOP
ADJUSTMENT
SCREW
HEX NUT
30 15
BEVEL
LOCK KNOB 
MITER TABLE
Fig. 43
30
