OPERATION
using your left hand, pull the starter grip and rope until the engine runs.
Set the start lever back to the run position.
NOTE: If the engine dies, set the start lever to the run position and pull the starter grip and rope until the engine starts.
Move to the rear of the machine and squeeze throttle lever to run.
To start a warm engine:
Move the start lever to the START position and then immediately back to the RUN position.
NOTE: This will set the carburetor to a fast idle setting for easier starting.
Pull the starter grip and rope until the engine starts.
To stop the engine:
Place the on/stop switch in the OFF ( O ) position.
cutting tips
See Figure 13.
Keep a firm grip with both hands while in operation.
If grass becomes wrapped around the string head, STOP THE ENGINE, disconnect the spark plug wire, and remove the grass.
Use the tip of line to do the cutting; do not force string head into uncut grass.
Wire and picket fences cause extra line wear, even breakage. Stone and brick walls, curbs, and wood may wear line rapidly.
Avoid trees and shrubs. Tree bark, wood moldings, siding, and fence posts can easily be damaged by the line.
TRANSPORTING THE UNIT
Turn on/stop switch OFF ( O ).
Make sure engine and exhaust are cool.
Keep unit level to prevent fuel spillage.
9 — English
