ASSEMBLY
MITER LOCK HANDLE
See Figure 8.
To install the miter lock handle, place the threaded stud on the end of the miter lock handle into the threaded hole in the control arm. Turn clockwise to tighten.
DUST BAG
See Figure 9.
A dust bag is provided for use on the miter saw. It fits over the exhaust port on the upper blade guard. Squeeze the two metal clips to open the mouth of the bag and slide it on the exhaust port. Release the clips. The metal ring in the bag should lock in between the grooves on the exhaust port. To remove the dust bag for emptying, simply reverse the above procedure.
WORK CLAMP
See Figure 10.
The work clamp provides greater control by clamping the workpiece to the fence. It also prevents the workpiece from creeping toward the saw blade. This is very helpful when cutting compound miters.
Depending on the cutting operation and the size of the workpiece, it may be necessary to use a
WARNING:
In some operations, the work clamp assembly may interfere with the operation of the blade guard assembly. Always make sure there is no interference with the blade guard prior to beginning any cutting operation to reduce the risk of serious personal injury.
To install the work clamp:
Place the shaft of the work clamp in either hole on the miter table base.
Rotate the knob on the work clamp clockwise to move it in or counterclockwise to move it out as needed.
TO
TIGHTEN
CONTROL ARM
MITER | TO |
|
LOCK HANDLE |
| |
| LOOSEN | Fig. 8 |
|
|
DUST
BAG
EXHAUST
PORT
Fig. 9
BASE | WORK |
| CLAMP |
Fig. 10
14
