ADJUSTMENTS
DANGER:
Laser radiation. Avoid direct eye contact with light source.
WARNING:
Use of controls or adjustments or performance of pro- cedures other than those specified herein can result in hazardous radiation exposure.
TO ADJUST THE LASER GUIDE
See Figure 34.
Use the work clamp or a
Plug the saw into the power source and make a slight cut to score the wood.
Release the switch trigger and allow the saw blade to stop rotating before raising the blade.
Raise the saw arm.
Unplug the saw.
Using the Phillips end of the supplied blade wrench, loosen the laser adjustment screw and move laser assembly until aligned.
NOTE: When properly aligned, the laser should be on the left edge of the kerf.
Holding the laser assembly, tighten the laser adjustment screw.
LASER
ASSEMBLY
LASER
ADJUSTMENT 
SCREW
Fig. 34
28
