OWNER’S MANUAL
INSTALLATION
Continued
DECORATIVE FACING
Any noncombustible material may be used for facing (glass, tile, brick, etc.) as long as
Air Shutter | Orifice | Burner |
| ||
|
|
WARNING: Improper installa- tion, adjustment, alteration, ser- vice, or maintenance can cause injury or property damage. Refer to this manual. For assistance or
the proper clearances are observed (see Clearances, page 4). IMPORTANT: Lou- vered openings must not be obstructed, and upper and lower panels must remain remov- able for servicing. Use only
Firebox Bottom
Venturi
Tube
Burner Gas Line
additional information, consult a qualified installer, service agency, or gas supplier.
| Left |
Back | Front |
Right
Figure 44 - Installing Logs “A” (Top View)
|
| Left |
| |
Back |
| A | Front | |
B | B | |||
|
| |||
|
|
| ||
|
| A |
|
Right
Figure 45 - Installing Logs “B ” (Top View)
|
| Left |
|
| D |
| C |
|
|
| |
Back |
| E | Front |
|
|
|
C 
D 
Right
Figure 46 - Installing Twigs “C, D, E ” (Top View)
securing facing material.
Note: Combustible material, such as wood, that has been fireproofed is not considered noncombustible.
PILOT ASSEMBLY ADJUSTMENT
The pilot assembly is factory preset for the proper flame height. Alteration to these set- tings may have occurred during shipping and handling. If this is the case, some minor adjustment may be necessary and should be done by a qualified technician. To access the pilot assembly, the glass door must be opened. The proper settings for the thermopile height should be at a distance of 3/8" to 1/2" from the pilot flame as shown in Figure 47.
1/8" |
|
(3mm) | 3/8" - 1/2" |
| |
|
Figure 47 - Correct Pilot Flame Pattern
BURNER FLAME ADJUSTMENT
The air shutter, located at the underside of the main burner (see Figure 48), has been factory preset to the proper
Figure 48 - Connecting Venturi and Orifice
CORRECT |
|
| Long, Blue Flame |
INCORRECT | with Yellow Tips |
| |
CLOSE |
|
SHUTTER | Short, Sharp, |
| Blowing Flame |
INCORRECT |
|
OPEN | Long, Uneven, |
SHUTTER | |
| Yellow Flame |
Figure 49 - Burner Flame Patterns
BURNER REMOVAL
CAUTION: Before proceed- ing, make sure the entire unit is cool.
1.Remove the top and bottom louvers and screen. Open the glass door (left or right side).
2.Carefully remove the log set.
3.Remove the screw that attaches the burner to the bracket.
4.Slide the burner towards the front of the unit, lift, and remove from the fire- box.
5.To reinstall the burner, slide the burner towards the rear of the unit and secure burner to bracket with screw.
CAUTION: Make certain the orifice is inside the venturi tube's air shutter, see Figure 48.
6.Replace the log set, close door with latches, and attach screen and louvers.
105706 | 19 |
