MAINTENANCE
CLEANING THE EXHAUST PORT AND MUFFLER
Depending on the type of fuel used, the type and amount of oil used, and/or your operating conditions, the exhaust port, muffler, and/or spark arrestor screen may become blocked with carbon deposits. If you notice a power loss with your gas powered tool, you may need to remove these deposits to restore performance. We highly recommend that only qualified service technicians perform this service.
SPARK ARRESTOR
The spark arrestor must be cleaned or replaced every 25 hours or yearly to ensure proper performance of your prod- uct. Spark arrestors may be in different locations depending on the model purchased. Please contact your nearest service dealer for the location of the spark arrestor for your model.
REPLACING AND CLEANING AIR FILTER
See Figures 19 - 20.
For proper performance and long life, keep air filter clean. For best performance, replace annually.
Remove the air filter cover by pushing down on the latch with your thumb while gently pulling on the cover.
Remove the air filter and clean it in warm soapy water. Rinse and let dry completely.
Reinstall the air filter.
Replace the air filter cover by inserting the tabs on the bottom of the cover into the slots on the air filter base; push the cover up until it latches securely in place.
FUEL CAP
WARNING:
A leaking fuel cap is a fire hazard and must be replaced immediately.
The fuel cap contains a
SPARK PLUG REPLACEMENT
This engine uses a Champion
AIR FILTER COVER
LATCH
PULL COVER
TO OPEN
Fig. 19
AIR FILTER
BASE
AIR FILTER
AIR FILTER
COVER
Fig. 20
17
