GENERAL SAFETY RULES
WARNING:
Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious personal injury.
READ ALL INSTRUCTIONS
For safe operation, read and understand all instructions before using this product. Follow all safety instructions. Failure to follow all safety instructions listed below can result in serious personal injury.
Do not allow children or untrained individuals to use this unit.
Never start or run the engine in a closed or poorly venti- lated area; breathing exhaust fumes can kill.
Clear the work area before each use. Remove all objects such as rocks, broken glass, nails, wire, or string which can be thrown or become entangled in the cutting line or blade.
Wear safety glasses or goggles that are marked to comply with ANSI Z87.1 standards and hearing protection when operating this unit.
Wear heavy, long pants, boots, and gloves. Do not wear loose fitting clothing, short pants, sandals, or go barefoot. Do not wear jewelry of any kind.
Product users on United States Forest Service land, and in some states, must comply with fire prevention regulations. This product is equipped with a spark arrestor; however, other user requirements may apply. Check with your federal, state, or local authorities.
Never operate this unit on the operator’s left side.
� Secure long hair above shoulder level to prevent entanglement in moving parts.
� Keep all bystanders, children, and pets at least 50 ft. (15 m) away. Bystanders should be encouraged to wear eye protection.
� Do not operate this unit when you are tired, ill, or under the influence of alcohol, drugs, or medication.
� Do not operate in poor lighting.
� Keep firm footing and balance. Do not overreach. Overreaching can result in loss of balance or exposure to hot surfaces.
� Keep all parts of your body away from any moving part.
� To avoid hot surfaces, never operate the unit with the bottom of the engine above waist level.
� Do not touch area around the muffler or cylinder of the unit; these parts get hot from operation.
Always stop the engine and remove the spark plug wire before making any adjustments or repairs except for carburetor adjustments. Wear your protective equipment and observe all safety instructions. When the unit is turned off, make sure the cutting attachment has stopped before setting the unit down.
Inspect the unit before each use for loose fasteners, fuel leaks, etc. Replace any damaged parts before use.
The string head or blade will rotate during carburetor adjustments.
It has been reported that vibrations from
a)Keep your body warm in cold weather. When oper- ating the unit wear gloves to keep hands and wrists warm. It is reported that cold weather is a major factor contributing to Raynaud’s Syndrome.
b)After each period of operation, exercise to increase blood circulation.
c)Take frequent work breaks. Limit the amount of exposure per day.
d)Keep the tool well maintained, fasteners tightened, and worn parts replaced.
If you experience any of the symptoms of this condition, immediately discontinue use and see your physician about these symptoms.
Mix and store fuel in a container approved for gasoline.
� Mix fuel outdoors where there are no sparks or flames. Wipe up any fuel spillage. Move 30 ft. (9 m) away from refueling site before starting engine. Slowly remove the fuel cap after stopping engine. Do not smoke when refueling.
Stop the engine and allow to cool before refueling or storing the unit.
Allow the engine to cool; empty the fuel tank and secure the unit from moving before transporting in a vehicle.
3
