Ryobi Outdoor RY30130, RY30120 manual Debris Flap Replacement, Storage 1 Month or Longer

MAINTENANCE

DEBRIS FLAP REPLACEMENT

See Figure 25.

Replace the debris flap if it is worn.

Using a 10 mm wrench or socket, remove the retaining nuts, washers, and debris flap.

Install the new debris flap. This replacement part is avail- able from the place of purchase, or by calling 1-800-242- 4672.

Replace retaining nuts and washers.

Tighten securely.

STORAGE (1 MONTH OR LONGER)

Drain all fuel from tank into a container approved for gasoline. Run engine until it stops.

Abide by all ISO and local regulations for the safe storage and handling of gasoline. Excess fuel should be used up in other 2-cycle engine powered equipment.

� Clean all foreign material from attachments. Do not grasp exposed cutting blades when picking up or holding the attachments.

Store idle unit indoors in a dry, well-ventilated area that is inaccessible to children. Keep away from corrosive agents such as garden chemicals and de-icing salts.

ATTACHING THE STORAGE HANGER

See Figure 26.

There are two ways to hang the attachment for storage.

� To use the hanger cap, push in the button and place the hanger cap over end of the lower end of attachment shaft. Slightly rotate the cap from side to side until the button locks into place.

� The secondary hole in the attachment shaft can be used for hanging purposes as well.

RETAINING NUTS EDGER GUARD

WASHERS

DEBRIS FLAP

Fig. 25

HANGER

CAP

HOLE

SECONDARY

HOLE

BUTTON

Fig. 26

19