Saeco Coffee Makers HD8836, HD8837 Priming the Water Circuit, it to the “, progress, be primed

Black

•Switch the power button to “I” to turn on the machine.

•The display shows the ON/OFF icon.

•Make sure the selector dial is set to the

“” position; if this is not the case, set it to that position.

•Press the ON/OFF button to turn the machine on.

Red

Priming the Water Circuit

• To prime the water circuit, place a
container under the steam/hot water
wand (Pannarello, if supplied).
• Turn the selector dial clockwise to set
it to the “	” position. The machine
starts the automatic priming of the
circuit by letting out a preset quantity
of water through the steam/hot water
wand (Pannarello, if supplied). The bar
under the icon shows the operation
progress.
At the end of the priming process,
the display shows an icon (see fig-
ure) indicating that the selection dial
must be brought back to the central
“ ”position.

•The display indicates that the circuit must be primed.

Red		Note: Before starting the
		machine after long periods
	of inactivity, the water circuit must
	be primed.

Orange

Orange

Green

• The display then shows the machine

warm-up icon, as shown in the fi gure.

When warm-up is complete, the machine performs a rinse

cycle of the internal circuits.

In this phase, this icon will be dis- played:

•When the operations described above are complete, this icon will be dis- played:

The machine is then ready to brew beverages.

•To brew coffee, dispense hot water or steam, and for a proper use of the ma- chine, carefully follow the instructions provided.

If the machine is being used for the first time or after a long period of inactivity, follow the

operations described in the follow- ing section.

• 8 •