BASIC OPTIONS

4.2.2 Using the Motion Detector

1.Open the battery compartment and insert the batteries (2x AA, alkaline).

2.Keep the TEST button (3) pressed for about 4 seconds. The LED will flash once. Release the button. The LED will flash twice. The motion detector has now chosen a unique code, which can be registered with your console.

3.Place the motion detector upside down so that it cannot detect any movement during registration.

Test mode: Testing the location of your motion detector

1.Set the switch to 1.

2.Press the TEST button (3) until the indicator (2) flashes twice.

3.Wait 20 seconds.

4.Walk in front of the sensor. The indicator (2) lets you know when a movement has been detected. This allows you to check whether the sensor has been mounted on the right place.

5.Press the TEST button again to be able to use the sensor as normal.

☺After 2 minutes the motion detector will go back to the normal mode.

4.2.3 Registering a Motion Detector

1.To access the menu, press the menu  or menu  button. The display will now read ‘ENTER PIN’.

2.Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). For every digit entered, a * will appear on the display.

3.When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.

4.Press OK. The display will read ‘INSTALL ZONE’.

5.Press the TEST button of the motion detector or turn it around, so that the sensor will detect movement. The console will beep to confirm. The display will read ‘ZONE …’. SET’.

☺A memory space for a sensor is called a zone. If you have more than 1 sensor installed, it will read e.g. ZONE 2 SET, ZONE 3 SET, … ZONE 30 SET.

☺You can choose in which zone you want to install the sensor. If you want to install the sensor in zone 3, press 3 on the number pad before executing step 5.

☺You will find a table at the back of this user manual in which you can write down which zone contains which sensor. We advise you to write down which sensor you have registered in which zone.

6.Repeat step 5 for every motion detector you wish to register.

7.Press CLEAR again to quit the menu. To confirm your choice, press 1 for Yes or 2 for No. If you choose Yes, you will quit the menu. If you choose No, you go back to the main menu.

☺Read chapter 12 for information on replacing the batteries.

16

MARMITEK