EXTRA OPTIONS
9.5 Emergency sensors (always mode)
Your system also gives you the option to turn any sensor registered with the system into a
A few examples:
•A panic button connected to the wired input on the console.
•A door or window that should not be opened at any time.
•A temperature or level sensor that warns you when a certain value or level is exceeded.
Transforming a sensor:
1.To access the menu, press the menu or menu button. The display will now read ‘ENTER PIN’.
2.Enter your
3.When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.
4.Use the menu buttons / to go to menu item 7. OPTIONS. Press OK to select this menu item. You can also go to this menu item directly by pressing a 7 on the number pad.
5.Use the menu buttons / to go to menu item SENSOR MODE. Press OK to select this menu item.
6.The display now reads SET ALWAYS SENSORS. You can see on your display (top and bottom) which zones and sensors have been registered.
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
S E T A L W A Y S
S E N S O R S
17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32
7.If you want to turn zone 31 into an emergency sensor, enter 31 on the number pad and press OK. Zone number 31 will start flashing.
8.If you also want to turn zone 5 into an emergency sensor, enter 5 on the number pad and press OK. Zone number 5 will start flashing.
9.If you want to turn zone 31 into a normal sensor again, enter 31 on the number pad and press OK. Zone 31 will stop flashing. 10.Press CLEAR again to quit the menu.
☺Make sure the DS90 Door/Window Sensor is set to MIN if you want the message to be passed on without a delay (see 8.1).
9.6 Deregistering a Door/Window Sensor
1.To access the menu, press the menu or menu button. The display will now read ‘ENTER PIN’.
2.Enter your
3.When the PIN code has been entered correctly, the word ‘INSTALL’ will show up on the display.
4.Press OK.
5.Enter the number of the zone you want to erase on the number pad and press CLEAR.
6.You are asked to confirm CLEAR ZONE 1. YES 2. NO.
7.Press 1 to erase the zone. The zone number is shown on the display.
8.Press CLEAR again to quit the menu.
☺Zones 31 and 32 cannot be erased.
SAFEGUARD / TOTALGUARD | 29 |