Samson HX410, HX115 manual Connecting the HX810 to Your Amplifier

Connecting the HX810

The HX810 impedance is 4 Ohms. So, when two HX810’s are connected together in parallel, the total impedance is 2 Ohms. The impedance of your speaker has an effect on your amplifier. In general, the lower the impedance, the more power your ampli- fier will put out.

ENGLISH

IMPORTANT: There is a minimum safe impedance so be sure to check the manufacturer’s recommended impedance for your amplifier to avoid

Hartke Systems

Distributed Exclusively by Samson Technologies Corp. Hicksville, New York 11802

EFFECT

any damage to your amplifier or void- ing your warranty.

Connecting the HX810 to Your Amplifier

The HX810 connections are made via a 1/4” phone jack or Speakon connector located on the rear panel jack-plate. Be sure to make your con- nection with un-shielded speaker cable. Connect the Amplifier Output to the speaker Input on the HX810’s rear jackplate.

	MODEL 2000
8	200 WATTS	SPEAKER OUTPUTS
	= 120 WATTS
4	= 200 WATTS