Speaker Setup
SPK Mode
Setting up Speaker Mode and Delay Time
1 |
| 2 |
|
|
| ||
Press the SPK Mode button. |
| Press the Left/Right (▲ / | ▲) button to select |
|
| the desired item. |
|
|
|
|
|
•Each time the button is pressed, a different mode selection is displayed on the front panel display as shown below.
S | Front speaker: Small |
| |
p |
| ||
|
| ||
e |
|
| |
a |
|
| |
k | Center speaker: Small | Center speaker: Not Used | |
e |
|
| |
r |
|
| |
M | Rear speaker: Small | Rear speaker: Not Used | |
o | |||
|
|
Setting up the Speaker Delay Time
When 5.1CH Surround Sound is played, you can enjoy the best sound if the distance between you and each speaker is the same. Since the sounds arrive at the listening position at different times depending on the placement of speakers, you can adjust this difference by adding a delay effect to the sound of the Center Speaker and Surround Speakers.
Ideal CENTER SPEAKER placement
Ideal SURROUND
SPEAKER placement
It is desirable to place all speakers within this circle.
Df: The distance from FRONT SPEAKER
Dc: The distance from CENTER SPEAKER
Ds: The distance from SURROUND SPEAKER
d |
|
| |
e |
| Subwoofer: Use | |
|
|
| |
|
|
| Setting up Delay Time from 00~05ms |
|
|
| |
Delay |
| Center Speaker Delay Time | |
|
|
| |
Time |
|
| Setting up Delay Time from 00~15ms |
|
|
| |
|
|
| Rear Speaker Delay Time |
|
|
|
|
•SMALL: When this setting is selected, low frequencies of below 200 Hz are assigned to the subwoofer only.
•USE: Select when using speakers.
•NONE: Select this when no speakers are installed.
•Setting CENTER SPEAKER
If the distance of Dc is equal to or longer than the distance of Df in the figure, set the mode as 0ms. Otherwise, change the setting according to the table.
•Setting REAR (SURROUND) SPEAKERS
If the distance of Df is equal to the distance of Ds in the figure, set the mode as 0ms. Otherwise, change the setting according to the table.
Distance between Df and Dc | Delay Time |
|
|
50 | 1.3 ms |
100 | 2.6 ms |
150 | 3.9 ms |
200 | 5.3 ms |
|
|
Distance between Ds and Dc | Delay Time |
|
|
200 | 5.3 ms |
400 | 10.6 ms |
600 | 15.9 ms |
|
|
SETUP
The display changes depending on the current audio output mode (DSP, PRO LOGIC,
Speaker delay time setting is a professional sound volume adjustment method for audio enthusiast. For home use, refer to "Setting up the Ideal Speaker Positions" on page 9 to install speakers in appropriate locations.
33 | 34 |