Connect Video to TV
Connecting the FM and AM(MW) Antennas
TV
Composite | Component |
Video | Video |
*Depending on your TV, Component Video input connectors may be marked as DVD Video input connectors.
Composite Video (Good Quality)
Connect the supplied video cable from the VIDEO OUT jack on the back panel of the system to the VIDEO IN jack on your television.
1
If FM reception is poor,
connect an outdoor FM antenna (not supplied).
FM Antenna (supplied)
2 | 3 | If AM reception is |
|
| poor, connect an |
|
| outdoor AM |
|
| antenna(not |
|
| supplied). |
AM Loop Antenna
(supplied)
ANTENNA
Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.
CONNECTIONS
S-Video (Better Quality)
Cooling fan (See “About Cooling Fan” below.)
If you television is equipped with an
Component Video (Best Quality)
If your television is equipped with Component Video inputs, connect a component video cable (not supplied) from the Pr, Pb and Y jacks on the back panel of the system to the corresponding jacks on your television.
• When the Progressive scan mode is selected, the VIDEO and
FM antenna connection
1.Connect the FM antenna supplied to the FM 75Ω
COAXIAL terminal as temporary measure.
2.Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.
•If reception is poor, connect an outdoor antenna. Before attaching a 75Ω coaxial cable (with a standard type connector), disconnect the supplied FM antenna.
AM(MW) antenna connection
1.Connect the AM loop antenna supplied
to the AM and terminals.
2.If reception is poor, connect an outdoor single
(About the cooling fan) |
| For safety, observe the following carefully. |
|
| |
A cooling fan is mounted on the rear panel of the center unit to | • Make sure there is good ventilation around the center unit. Poor | |
prevent abnormal temperature inside the center unit, thus assuring | ventilation could overheat and cause damage. | |
normal operation. The cooling fan automatically starts rotating to | • DO NOT block the cooling fan and the ventilation openings or | |
supply external cool air to the inside of the center unit when the | holes. (If they are blocked by a newspaper or cloth, etc., the heat | |
internal temperature exceeds the specified limit. | may not be able to escape.) | |
|
|
|
11 | 12 |