Before Calling for Service
Symptom | Check | Remedy |
Can't turn it on.
It does not work when the button is pressed.
Sound is not produced.
Picture does not appear when the function is selected.
Remote controller does not work.
The sound from each device is changed during stereo playback.
Can't receive
broadcasting.
There is no sound from
surround speaker.
There is no sound from
center speaker
•Isthepowercodepluggedintotheoutlet?
•Is there static electricity in the air?
•Are the speaker and external component connected properly?
•Does the Mute function work?
•Is the volume set to minimum?
•Is the speaker setup selected to NONE?
•Isn’t the external component connected properly?
•Are the batteries exhausted?
•Is the distance between remote control and main unit proper?
•Is the left/right speaker or left/right input/output code connected properly?
•Is AM or FM antenna connected properly?
•Is the surround speaker connected properly?
•Is S.SPK (Surround) set to NONE in Speaker Setup?
•Is Surround Mode selected to Stereo?
•Is the center speaker connected properly?
•Is C.SPK (Center) selected to NONE in Speaker Setup?
•Is the Surround Mode selected to Stereo?
•Connect the power plug to the outlet.
•Disconnect the power plug and connect it again.
•Properly connect it.
•Press Mute button to cancel the function.
•Adjust the volume.
•Refer to pages 20~21 to select LARGE, SMALL or YES.
•Properly connect it.
•Replace with new batteries.
•Operate at close distance.
•Check the left/right channel and properly connect it.
•Properly connect the antenna.
•If the input strength of antenna connector is weak, install the FM antenna in a place with good reception.
•Refer to pages 10~11 to connect it properly.
•Refer to pages 20~21 to select LARGE or
SMALL.
•Refer to pages 30~37 to select other Surround Mode.
•Refer to pages 10~11 to connect it properly.
•Refer to pages 20~21 to select LARGE or
SMALL.
•Refer to pages 30~37 to select other Surround Modes.
46