INSTALLING THE INDOOR UNIT
Connecting the Assembly Cable (cont.)
Control Box |
A |
B |
❊The conduit kit is optional(A and B).
C | Control Box |
| |
| E |
D Terminal |
block |
cover |
5Detach the control box from the indoor unit.
6Install the conduit kit. (The conduit kit is optional)
7Pass the assembly cable through the rear of the indoor unit and connect the assembly cable to terminals as shown in the figure.
➢Each wire is labelled with the corresponding terminal number.
8Pass the other end of the cable through the 65mm( 2 169 inch) hole in the wall.
9Reinstall the control box, then tighten the C screw.
➢The C screw is provided with this manual.
10Install the D terminal block cover, tightening the E screws.
➢The D terminal block cover and E screws are provided with this manual.
11Replace the front panel, carefully tightening the screws.
12Reinstall the front grille.
13For further details on how to plug the other end of the assembly cable into the outdoor unit, refer to page 40.
Indoor unit
1 2 3 | E | Earth |
terminal |
Outdoor 1 | 2 | 3 | E |
unit |
|
|
|
A1 | A2 | A3 | E |
Earth terminal 
