INSTALLING THE AIR CONDITIONER
Connecting the Assembly Cable
Indoor Unit | N 1 | 1 | 2 | 3 |
E | N1 | N1 | 2 | 3 |
E | N1 | 1 | 2 | 3 |
Outdoor Unit | N 1 | 1 | 2 | 3 |
**Screws on terminal block must not be unscrewed with the torque less than 12 kgf.cm.
The designs and shape are subject to change according to the model.
The outdoor unit is powered from the indoor unit through the assembly cable. If the outdoor unit is more than 5 meters away from the indoor unit, you must extend the cable. The maximum length of the cable is 15 meters.
1Extend the assembly cable if necessary. .
2Remove the cover terminal on the side of the indoor unit.
3Pass the assembly cable through the rear of the indoor unit and connect the assembly cable to terminals as seen in the picture.
Each wire is labeled with the corresponding terminal number.
4Pass the other end of the cable through the 65mm hole in the wall.
5Close the connector cover tightening the screw carefully.
6Close the cover terminal.
7Remove the terminal board cover on the side of the outdoor unit.
8Connect the cables to the terminals as seen in the picture.
Each wire is labeled with the corresponding terminal number.
9Connect the earth conductor to the earth terminals.
10Close the terminal board cover tightening the screw carefully.
Specially for Russian and European market, Before installation, the supply authorithy should be consulted to determine the supply system impedance to ensure compliance.
Power cable specification
Model | Power cable | Interconnection cable | |
|
|
| |
**07** | - | 5G, 0.75mm2 | |
|
| ||
**09** | - | 5G, 1.0mm2 | |
|
|
Connect the power cable to the auxiliary circuit breaker If every pole fails to connect to the power supply, it must be incorporated in a wire with a contact opening of >3mm.
