![](/images/new-backgrounds/1180754/18075463x1.webp)
Accessories
Accessories in the outdoor unit case
If using a multi system, refer to the manual supplied with the outdoor unit.
Assembly Cable (1)
3-wire
Assembly Cable (2)
Drain Plug (1)
Rubber Leg (4)
• The flare nuts are attached to the end of each pipe of an evaporator or a service port. Use the nuts when connecting the pipes.
•The assembly cable is optional. If it is not supplied, use the standard cable.
•The drain plug and rubber leg are only included when the air conditioner is supplied without the assembly pipe as seen in the picture below.
Optional accessories
If using a multi system, refer to the manual supplied with the outdoor unit.
The following connection accessories are optional. If they are not supplied, you should obtain them before installing the air conditioner.
Insulated Assembly Pipe, Ø6.35 mm (1)
Insulated Assembly Pipe, Ø9.52 mm (1)
09/12
Insulated Assembly Pipe, Ø12.70 mm (1)
18
Insulated Assembly Pipe, Ø15.88 mm (1)
24
PE T3 Foam Tube
Insulation (1)
Vinyl Tapes (2)
Drain Plug (1)
Rubber Legs (4)
Pipe Clamps A (3)
Pipe Clamps B (3)
Cement Nails (6)
M4 x 25 Tapped
Screws (6)
Drain Hose,
length 2 m (1)
Putty 100 g (1)
Foam Insulation(1)
• If these accessories are supplied, they will be in the accessory box.
Tools required for installation
General Tools
• Vacuum Pump(Backward flowing prevention) | • Manifold Gauge | • Stud Finder | ||
• Torque Wrench | • Pipe Cutter | • Reamer | • Pipe Bender | • Spirit Level |
• Screw Driver | • Spanner | • Drill | • L Wrench | • Measuring Tape |
Tools for test operations
• Thermometer | • Resistance Meter • Electroscope |
English-32
Maldives ET
2016/5/16 10:26:46