Samsung BW-4302 instruction manual Connecting to Monitor, Connecting to Power

CONNECTION

Connecting to Monitor

Connect the VIDEO out jack to the monitor video in jack.

CONNECTION

Connecting to Power

Each model has the different power source and the operation characteristics.

Make sure the power is supplied to the appropriate power terminals on the camera. Connect the power as referred on the following figures.

CCD Camera Monitor

•As a connecting method varies according to instruments, refer to the manual supplied with the instrument.

•Connect the cable after power is turned off.

•Set the 75Ω/Hi-Z selection switch as shown below if you have intermediate device.

AC24V, 60Hz : BW-4302EA

AC24V, 50Hz : BW-4302CA

Intermediate

VIDEO

75 Hi-Z

IN OUT

VIDEO

75 Hi-Z

IN OUT

AC230V , 50Hz : BW-4302CH

Notes:

• Be sure to connect power cord after you finish installation.

• Check whether the frequency of power is 60Hz to use the linelock(L.L) mode in EIA models.

CCD Camera End monitor

• Check whether the frequency of power is 50Hz to use the linelock(L.L) mode in CCIR models.

22 B W CCD CAMERA B W CCD CAMERA 23