Samsung AA68-03265A-00, CFTD2085, CFTD2785 manual Connecting a Second VCR to Record from the TV

03233A(E)-CHAPTER 2 11/28/03 1:34 PM Page 4

I N S TA L L AT I O N

5

Connect another cable between the other OUT terminal on the splitter and the A–IN terminal on the RF (A/B) switch.

6

Connect the last coaxial cable between the OUT terminal on the RF (A/B) switch and the VHF/UHF terminal on the rear of the TV.

After you’ve made this connection, set the A/B switch to the “A” position for normal view- ing. Set the A/B switch to the “B” position to view scrambled channels. (When you set the A/B switch to “B,” you will need to tune your TV to the cable box’s output channel, which is usually channel 3 or 4.)

Connecting a Second VCR to Record from the TV

Your TV can send out signals of its picture and sound to be recorded by a second VCR.

To do this, connect your second VCR as follows:

1

Connect a coaxial cable between the ANTENNA OUT terminal on the VCR and the antenna terminal on the TV.

A coaxial cable is usually included with a VCR. (If not, check your local electronics store).

2

Connect a set of audio cables between the VIDEO/AUDIO OUT jacks on the TV and the VIDEO/AUDIO IN jacks on the VCR.

(The VCR input jacks might be either on the front or on back of the VCR.)

If you have a mono VCR, connect L(mono) to VCR audio out using only one audio cable.

Refer to your VCR’s instructions for more information about how to record using this kind of connection.

CHAPTER TWO: INSTALLATION 2.4