EN 2 / INSTALLING YOUR DISHWASHER
FITTING THE DOOR PANEL (Cladding with 2 elements)
- To fit the first section, please refer to the pre- vious chapter “FITTING THE DOOR PANEL (Cladding with a single panel) (Figs. 5.1 et 5.2).
-Position your door panel by engaging the 2 screws in the holes in the dishwasher’s door (Fig. 6.2 A)
-If there is any difficulty screwing, move the
screw P6 22 mm.
-Place the wood panel flat against the door (Fig. 6.2 A).
-Open the dishwasher’s door while holding the panel flat up against the door. Centre the wood panel at the sides with respect to the control panel, if necessary. Insert the 4
screws P8 (Fig. 6.2 A).
-Measure the distance between the drawer and the door panel on the adjacent unit (Fig. 6.3).
-Place the false drawer front taking into account the distance just measured (using a wedge with a good thickness).
-Open the dishwasher’s door while holding the false drawer front up against the door. Centre the wood panel at the sides with res- pect to the door panel. Insert the 2 screws P7 and the 2 screws P8 (Fig. 6.4).
Warning :
If the wood panel is very hard, ensure that you make an initial hole before screwing it on.
Warning :
Then total weight of the door panel and the false drawer front must not exceed 10kg maximum.
Fig. 6.1 A |
Fig. 6.2 A |
|
|
| = | = |
|
| |
Fig.6.3 |
|
|
+ |
| = |
Fig.6.4
10
