Samsung DMB58AHC/AND, DM-B58AHC/XET manual Draining Away the Waste Water FIG

EN 2 / INSTALLING YOUR DISHWASHER

• DRAINING AWAY THE WASTE WATER: FIG. 2

You can connect the end of the drain hose to:

-A ventilated U-bend or

-A sink U-bend

When connecting to a U-bend, you must remove the flapper from the U-bend. Then fully install the rubber end. If necessary, add a tightening collar P10 .

If necessary, you can increase the hose’s length (up to 3m maximum). In this case, check that the appliance drains correctly. The hose must rest on the floor and only rise vertically close to the drainage system.

For appliances installed in vertical units, the drainage system must not rise higher than the top of the appliance.

NB:

Ensure that the drain hose is held in place with a tie to avoid any potential flooding.

The drain connection must be 0.40m (minimum) to 0.90m (maximum) above the floor.

Make sure that you adhere to the maximum dimensions for the fitting of the drainage tube in the siphon pipe

Important:

When fitting the hose, pull on it gra- dually so as not to kink it B .

Avoid any kinks or constrictions in the hose, which could prevent the water from passing or slow down its flow.

	65°C max
	1-10 bars
	> 1l/min
		15 cm
		maxi
	20 cm mini	5 cm + 25minicm
90 cm maxi		mini
0 - 40 cm
Fig. 2
		6