EN |
| 2 / INSTALLING YOUR DISHWASHER |
|
|
|
•FITTING THE DOOR PANEL (Cladding with a single panel)
-Measure the distance between the floor and the bottom of the door panel on the adjacent unit (Dimension B, Fig. 5.1)
-Measure the distance between the floor and the marking on the bottom of the door panel (Dimension A)
-Calculate Dimension D = A - B, and draw a line for Dimension D on the back of the panel at the bottom (Fig. 5.2)
-Set the positions for the two screws at 262mm from the wood panel’s axis and insert two screws P6 . (Fig. 5.2)
-Position your door panel by engaging the 2 screws in the holes in the dishwasher’s door (Fig. 6.1)
-If there is a problem with screwing, offset the
screw P6 by 22 mm.
-Place the wood panel flat against the door (Fig. 6.2).
-Open the dishwasher’s door while holding the panel flat up against the door. Centre the wood panel at the sides with respect to the control panel, if necessary. Insert the 2 screws P7 and the 4 screws P8 (Fig. 6.2).
Warning :
If the wood panel is very hard, ensure that you make a hole in advance before scre- wing the panel on.
NB :
If your appliance is supplied with a sound insulation sheet, glue this on before installing the door panel.
| (22) |
|
|
|
| A | B |
|
|
| |
| B |
|
|
Fig. 5.1 |
| ||
| 262 | 262 |
|
|
|
| |
| D |
| D |
|
|
| |
| ✍ |
|
|
Fig. 5.2 |
|
|
|
Fig. 6.1 |
Fig. 6.2 |
9
