EN 2 / INSTALLING YOUR DISHWASHER

• REFITTING THE PLINTH

Refit the plinth, cutting it away if necessary according to Dimension P (see table and Fig. 10.1)

Calculate dimension P (Table on last page):

P

- Take Dimension B from Fig. 6.1 and measure

 

the gap J between the floor and the bottom of

 

the dishwasher. Calculate B - J.

 

- Measure the plinth depth E (Fig. 10.1) bet-

P

ween the unit’s plinth and front of the unit.

E

Take the value for P from the table provided by

Fig. 10.1

E and B – J (e.g. if E = 100 and B – J = 140,

 

then P = 23).

 

- Cut away the plinth across a width of 600mm

 

to the depth for the value for P.

 

If there will be a specific plinth for the dis- hwasher, you must obtain a separate fixing kit (32X3252) from the After-Sales Department. In this case, the plinth height is H = B - P (Fig. 10.2).

Fig. 10.2

• TABLE FOR CUTTING AWAY THE PLINTH

Cut-away depth P =

B J

12