Samsung DP515A2GK01US user manual Setting a User Password, Setting Up a Boot Password

Setting a Boot Password

	Enter a password, press <Enter>, re-enter the password for
3 confirmation, and press <Enter> again.
	The password can be up to 8 alphanumeric characters.
	Special characters are not allowed.
4	The supervisor password has been set.
	The supervisor password is required to turn the computer on

or to enter the BIOS Setup.

For some models, if the password entered message appears in the Setup Notice window, the settings are not complete until the <Enter> key is pressed.

Chapter 4. 99

Settings and Upgrade

Setting a User Password

Using the User Password, you can turn the computer on but you cannot change the major settings of the BIOS Setup because you cannot enter the BIOS Setup.

This helps prevent unauthorized access to the major settings in the BIOS Setup menu.

Before configuring a user password, a supervisor password must have been configured. Deactivating the supervisor password also deactivates the user password.

In the Set User Password item, press <Enter> and complete the procedures from Step 3 of Setting a Supervisor Password.

Setting Up a Boot Password

To setup a boot password, the administrator password (Set Supervisor Password) should be set in advance.

Set the Password on boot item to Enabled.

Once a boot password is set, you have to enter a password to boot up the computer.

Be sure to remember the password for later use.