
Connecting the drain hose
CAUTION
Do not extend the drain hose.
•Since water may leak from the connected part, be sure to one long drain hose instead of connecting short ones. If you cannot help connecting more than one hose, be sure to seal the connected parts with silicone sealant. (Do not use the electric insulating tape for sealing.)
The end of the drain hose can be positioned in three ways:
A
B C
Connecting the direct-hose
1.Over the edge of a wash basin: The drain hose must be placed lower than 90 cm. If the end of the drain hose needs to be placed above the ground,
we recommend a height of 60−90 cm
(*). To keep the drain hose spout bent, use the supplied plastic hose guide. Secure the guide to the wall with a hook or to the tap with a piece of string to prevent the drain hose from moving.
2.Assemble the drain hose (A) and the
hose guide (B) and fix them with the
3.You can drain the condensed water by connecting the accessory hose (long drain hose) to the
Installation
You can immediately drain the condensed water that comes out while drying, by connecting the drain hose to the tap.
1. Assemble the hose connector (A) and
the hose.
|
| CAUTION |
A | Since there is a danger of water leaking | |
|
|
from the hose connecter and accessory hose, make sure that they are connected firmly.
English 21